imagistics DL850 Operating Manual page 236

Erasing Outside of the Original (Non-Image Area Erase) (continued)
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select magnification and copy size, as desired.
5.
Enter the desired print quantity from the control panel keypad.
6.
Position original FACE DOWN on the platen glass.
7.
Press [ Start ].
9-30
DETAILS
• APS and AMS are automatically released.
• Copy mode is automatically set to 1a1. When selecting 1a2 mode,
Platen store mode will function automatically.
HINT
See p. 3-7 for details on setting print quantity.
Reminder!
DO NOT CLOSE THE EDH.
Original size should be larger than 10mm x 10mm.
DETAILS: Oblique Erase and Rectangle Erase Modes
The Non-image area erase has two modes; Rectangle erase mode and
Oblique erase mode. The copier is initially set to select either mode appro-
priate for the original placed on the platen glass (AUTO mode).
Key Operator can specify either mode and the original density level manu-
ally so that the Non-Image Area Erase functions without fail.
See p. 13-52.
Having Any Problem?
This function may perform incorrectly if the lighting in the work place is
directly over the platen glass. In this case, consult your service representa-
tive about an appropriate place for installation.
Oblique erase mode Rectangle erase mode