Loading Tabbed Sheets In Multi-Sheet Bypass Tray - imagistics DL850 Operating Manual

Loading Tabbed Sheets in Multi-Sheet Bypass Tray

Rear
Front
Rear
Front
1.
Open the Multi-sheet bypass tray located on the right side of the
copier.
2.
Load tabbed sheets as illustrated above.
3.
Adjust the paper guides to the paper size.
4.
Specify the paper type as TAB for the Multi-sheet bypass tray.
2-30
Example: 3 Tabbed sheets loaded in position for one finished set.
Printed
side
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Printed
side
Reminder!
The tab extension width should be 12.5mm or less.
HINT
See p. 3-30 to p. 3-33 for specifying the paper type of the Multi-sheet
bypass tray.
Loading Paper (continued)
1st TAB
Section 1 2nd TAB
Introduction
3rd TAB
1st TABS
2nd TABS
Section 1 3rd TABS
Section 1
Introduction
Section 1
Introduction
Introduction
1st TAB
Section 1
2nd TAB
Introduction
3rd TAB
ONE FINISHED SET
1st TAB
2nd TAB
Section 1 Section 1
Introduction
Introduction Introduction
3rd TAB
3 FINISHED SETS
Section 1