Erasure - imagistics DL850 Operating Manual

Copying Image in the Center of Copy Paper (AUTO Layout) (continued)
• Non-Image Area Erase will be selected automatically. When using EDH
to scan the original, touch to deselect this function.
• When using the Book Copy with this function, the original smaller than
the selected copy size will be printed in the center of the copy paper
without image division performed.
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select the desired magnification and copy size on the Basic Screen.
• APS and AMS are automatically released, and 1.000 (100%) is selected
as a magnification ratio.
• Copy mode is automatically set to 1a1. When selecting 1a2 mode,
Platen store mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original(s) FACE UP in the EDH or FACE DOWN on the
platen glass.
For details on positioning originals, see p. 3-2 to p. 3-6.
DO NOT close the EDH when Non-Image Area Erase is selected.
Placing original obliquely on the platen glass may cause black copy marks.
7.
Press [ Start ].
When the finisher / trimming unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
The AUTO layout function may not operate properly if the lighting in the
work place is directly over the platen glass. In this case, consult your ser-
vice representative about an appropriate place for installation.
DETAILS
HINT
HINT
Reminder!
CAUTION
Having Any Problem?
Application
Selection Screen
Sheet/Cover
Insertion
Chapter
Combination
Booklet
Transparency
Interleave
Image Insert
Book Copy
Program Job
Non-Image
Area Erase
Reverse
Image
Repeat
9
Applications
Frame/Fold

Erasure

AUTO
Layout
All-Image
Area
Image Shift
Reduce &
Shift
Stamp
Overlay
9-43
Overlay
Memory