imagistics DL850 Operating Manual page 97

Making Single-Sided Copies from Double-Sided Originals (2a a a a 1)
3.
Select additional copy conditions, as desired.
Some incompatible conditions may automatically release the selected
copy mode. In this case, arrange the settings so that they are compatible
with the selected copy mode.
4.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
5.
Position originals FACE UP in the EDH according to the original
direction specified in step 2 .
• See p. 3-2 to p. 3-6 for details on positioning originals.
• Use EDH store mode (p. 3-34 to p. 3-35) when the original count
exceeds 100.
6.
Press [ Start ].
The machine starts to scan originals, then prints simplex copies when ready for
output.
Press [ Stop ] to suspend the scanning or printing job.
When the finisher / trimming unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
DETAILS
HINT
HINTS
CAUTION
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Copy Size
Lens Mode
Density
1-1, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
Finisher
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-29