Function Setting - imagistics DL850 Operating Manual

[4] E.C.M. (Electronic Copy Monitor) Function Setting (continued)
[3] E.C.M. Function Setting
Use this function to turn ECM On or Off, or to select whether the machine will stop
when the count limit is reached, or if the copier will complete the copy job before
stopping when reaching maximum copy count.
ECM Setting Menu Screen
Procedure
1 Touch [4] E.C.M. function setting on the Key Operator Mode Screen. Enter an 8-digit
ECM master key code, then touch OK to display the ECM Setting Menu Screen.
NOTE:
If an invalid ECM master key code is entered, continue by entering the
valid 8-digit code.
2 Touch [3] E.C.M. function setting . The ECM Function Setting Screen will be
displayed.
3 Touch ECM On to activate ECM or touch ECM Off to de-activate ECM.
The selected key will be highlighted.
4 Touch Immediately to stop the machine at once when the copy limit is reached.
In this case, copy conditions selected for the current job will be cleared. To continue
the job using the same user password, change the copy limit of the password or clear
the copy count.
Touch After job to stop the machine after the current job is completed, when copy limit
is reached.
Touch Warning to only display a warning message when copy limit is reached.
The selected key will be highlighted.
5 Touch OK to complete the setting and return to the ECM Setting Menu Screen.
6 If other ECM setting changes are required, touch desired key, from [1]~[3].
7 Touch PREVIOUS SCREEN to restore the Key Operator Mode Screen.
8 If no further changes are required, touch PREVIOUS SCREEN to restore the Basic
Screen to perform copying operations.
ECM Function Setting Screen
Key Operator
Mode
System Initial
Setting
Copier Initial
Setting
User Setting
Mode
E.C.M.
Lock/Delete
Program
Memory
Paper Type/
Special Size
Panel Contrast/
Key Sound
Key Operator
Data Setting
Weekly
Timer
Control Panel
Adjustment
Tray Auto
Select Setting
Energy
Saver Setting
Memory
Switch
Machine
Management
List Print
Call Remote
Center
Side 2 Lens
Adjustment
Finisher
Adjustment
HDD
Management
Non-Image
Area Erase
Timing
Adjustment
Centering
Adjustment
13
13-21
Key Operator
Mode