imagistics DL850 Operating Manual page 247

Eliminating Black Copy Marks Along Borders (Frame/Fold
Use the touch screen keypad or up/down arrow key to enter the desired erasure
amount, from 1 to 300mm in 1mm increments.
To specify Fold Erasure amount:
• Touch to highlight FOLD , if not highlighted, then use the touch screen keypad or
up/down arrow key to enter the desired erasure amount, from 1 to 99mm in 1mm
increments.
5.
Touch OK .
The Application Selection Screen will be restored.
6.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
7.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
8.
Position original(s) FACE UP in the EDH or FACE DOWN on the
platen glass.
For details on positioning originals, see p. 3-2 to p. 3-6.
When lowering the EDH onto thick original (e.g. open book), do not press it
down too hard. Keep the EDH open, if required.
9.
Press [ Start ].
When the finisher / trimming unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
HINT
HINT
DETAILS
CAUTION
Erasure) (continued)
Application
Selection Screen
Sheet/Cover
Insertion
Chapter
Combination
Booklet
Transparency
Interleave
Image Insert
Book Copy
Program Job
Non-Image
Area Erase
Reverse
Image
Repeat
9
Applications
Frame/Fold
Erasure
AUTO
Layout
All-Image
Area
Image Shift
Reduce &
Shift
Stamp
Overlay
9-41
Overlay
Memory