Disable Ripng Triggerupdate - Extreme Networks ExtremeWare XOS Command Reference Manual

RIPng Commands

disable ripng triggerupdate

disable ripng triggerupdate {vlan <vlan-name> | tunnel <tunnel_name> |
[vlan | tunnel] all}
Description
Disables the trigger update mechanism. Triggered updates are a mechanism for immediately notifying a
router's neighbors when the router adds or deletes routes or changes their metric.
Syntax Description
vlan-name
tunnel-name
all
Default
Enabled.
Usage Guidelines
Triggered updates occur whenever a router changes the metric for a route and it is required to send an
update message immediately, even if it is not yet time for a regular update message to be sent. This will
generally result in faster convergence, but may also result in more RIPng-related traffic.
When this feature is disabled, any metric change on the interface, or an interface going down will not
be communicated until the next periodic update. To configure how often periodic updates are sent, use
the following command:
configure ripng updatetime
Example
The following command disables the trigger update mechanism:
disable ripng triggerupdate
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
1266
Specifies an IPv6 configured VLAN.
Specifies an IPv6 tunnel.
Specifies all interfaces.
ExtremeWare XOS 11.3 Command Reference