Create Tunnel 6To4 - Extreme Networks ExtremeWare XOS Command Reference Manual

Version 11.3

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

IPv6 Unicast Commands

create tunnel 6to4

create tunnel <tunnel_name> 6to4 source <source-address>

Creates an IPv6-to-IPv4 (6to4) tunnel.

Syntax Description

source-address

Usage Guidelines

This command will create a new IPv6-to-IPv4 (also known as a 6to4 tunnel), and add it to the system. A

maximum of 1 6to4 tunnel can be configured on any particular virtual router. The tunnel name must be

unique and cannot overlap the same name space as VLANs, other tunnels, or virtual routers. The source

address of the tunnel must be one of the IPv4 addresses already configured on the switch. You cannot

remove an IPv4 address from the switch if a tunnel is still exists that uses it.

The following command creates the 6to4 tunnel link35 with source address 192.168.10.1:

create tunnel link35 6to4 source 192.168.10.1

This command was first available in ExtremeWare XOS 11.2.

Platform Availability

This command is available on all platforms.

Specifies an IPv6 tunnel.

Specifies an IPv4 address for the tunnel.

ExtremeWare XOS 11.3 Command Reference

Extremeware xos 11.3