Enable Ospfv3 - Extreme Networks ExtremeWare XOS Command Reference Manual

OSPFv3 Commands

enable ospfv3

enable ospfv3 {domain <domainName>}
Description
Enables OSPFv3 for the router.
Syntax Description
domainName
Default
N/A.
Usage Guidelines
When OSPFv3 is enabled, it will start exchanging Hellos on all of it's active interfaces. It will also start
exporting routes into OSPFv3 routing domain from other protocols, if enabled.
When OSPFv3 is disabled, it will release all the run-time allocated resources like adjacencies, link state
advertisements, run-time memory, etc.
OSPFv3 can be enabled successfully if and only if:
At least one of the VLANs in the current virtual router has one IPv4 address configured
●
—OR—
You explicitly configure the OSPFv3 router ID, a four-byte, dotted decimal number
●
Example
The following command enables OSPFv3 for the router:
enable ospfv3
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on platforms with a Core or an Advanced Core license.
1390
Specifies an OSPFv3 domain. OSPF-Default is the only one currently
supported.
ExtremeWare XOS 11.3 Command Reference