Extreme Networks ExtremeWare XOS Command Reference Manual page 801

Usage Guidelines
NOTE
The BlackDiamond 8800 family of switches and the Summit X450 switch do not support user-created VRs.
You must be running the SSH2 module (ssh.xmod), which is under Export Control, in order to use the
SCP2 command.
SSH2 does not need to be enabled on the switch in order to use this command.
This command logs into the remote host as
prompted for a password from the remote host, if required.
Host Name, User Name, and Remote IP Address Character Restrictions. This section provides information
about the characters supported by the switch for host names and remote IP addresses.
When specifying a host name, user name, or remote IP address, the switch permits only the following
characters:
Alphabetical letters, upper case and lower case (A-Z, a-z)
●
Numerals (0-9)
●
Period ( . )
●
Dash ( - ) Permitted for host and user names
●
Underscore ( _ ) Permitted for host and user names
●
Colon ( : )
●
At symbol ( @ ) Permitted only for user names
●
Slash ( / ) Permitted only for user names
●
When naming the host, creating a user name, or configuring the IP address, remember the requirements
listed above.
Remote Filename Character Restrictions. This section provides information about the characters
supported by the switch for remote filenames.
When specifying a remote filename, the switch permits only the following characters:
Alphabetical letters, upper case and lower case (A-Z, a-z)
●
Numerals (0-9)
●
Period ( . )
●
Dash ( - )
●
Underscore ( _ )
●
Slash ( / )
●
When naming a remote file, remember the requirements listed above.
Example
The following command copies the configuration file test.cfg on host system1 to the switch:
scp2 admin@system1:/config/test.cfg localtest.cfg
ExtremeWare XOS 11.3 Command Reference
and accesses the file
<user>
. You will be
<remote_file>
scp2
801