Disable Bgp Export - Extreme Networks ExtremeWare XOS Command Reference Manual

disable bgp export

disable bgp export [direct | ospf | ospf-extern1 | ospf-extern2 | ospf-
inter | ospf-intra | rip | static] {address-family [ipv4-unicast | ipv4-
multicast]}
Description
Disables BGP from exporting routes from other protocols to BGP peers.
Syntax Description
direct
ospf
ospf-extern1
ospf-extern2
ospf-inter
ospf-intra
rip
static
address-family
Default
Disabled.
If no address family is specified, IPv4 unicast is the default.
Usage Guidelines
The exporting of routes between any two routing protocols is a discreet configuration function. For
example, you must configure the switch to export routes from OSPF to BGP and, if desired, you must
configure the switch to export routes from BGP to OSPF. You must first configure both protocols and
then verify the independent operation of each. Then you can configure the routes to export from OSPF
to BGP, and the routes to export from BGP to OSPF. Similarly for BGP and ISIS, or BGP and RIP.
You can use policies to associate BGP attributes including Community, NextHop, MED, Origin, and
Local Preference with the routes. Policies can also be used to filter out exported routes.
Using the command to redistribute routes complements the redistribution of routes using the
export
configure bgp add network
to BGP only if the route is present in the routing table. The
an individual route from the routing table to BGP. If you use both commands to redistribute routes, the
routes redistributed using the
command.
export
ExtremeWare XOS 11.3 Command Reference
Specifies direct routing.
Specifies OSPF routing.
Specifies OSPF-extern1 routing.
Specifies OSPF-extern2 routing.
Specifies OSPF-inter routing.
Specifies OSPF-intra routing.
Specifies RIP routing.
Specifies static routing.
The address family to which the IGP routes will be exported. BGP supports two
address families: IPv4 Unicast and IPv4 Multicast.
command. The
configure bgp add network
command take precedence over routes redistributed using the
network
command adds the route
command redistributes
enable bgp export
disable bgp export
1483