Configure Bgp Peer-Group Send-Community - Extreme Networks ExtremeWare XOS Command Reference Manual

configure bgp peer-group send-community

configure bgp peer-group <peer-group-name> {address-family [ipv4-unicast |
ipv4-multicast]} [send-community | dont-send-community]
Description
Configures whether communities should be sent to neighbors as part of route updates.
Syntax Description
peer-group-name
address-family
send-community
dont-send-community
Default
If no address family is specified, IPv4 unicast is the default.
Usage Guidelines
These settings apply to the peer group and all neighbors of the peer group.
Example
The following command configures communities to be sent to neighbors as part of route updates:
configure bgp peer-group outer send-community
History
This command was first available in ExtremeWare XOS 10.1.
This command required an Advanced Core license in ExtremeWare XOS 11.1.
Platform Availability
This command is available on platforms with a Core or an Advanced Core license.
ExtremeWare XOS 11.3 Command Reference
Specifies a peer group.
The address family. BGP supports two address families: IPv4 Unicast and IPv4
Multicast
Specifies that communities are sent to neighbors as part of route updates.
Specifies that communities are not sent to neighbors as part of route updates.
configure bgp peer-group send-community
1461