Configure Rip Vlan Route-Policy - Extreme Networks ExtremeWare XOS Command Reference Manual

RIP Commands

configure rip vlan route-policy

configure rip vlan [<vlan-name> | all] route-policy [in | out] [<policy-
name> | none]
Description
Configures RIP to ignore certain routes received from its neighbor, or to suppress certain routes when
performing route advertisements.
Syntax Description
vlan-name
all
policy-name
none
Default
N/A.
Usage Guidelines
Use the option to configure an input route policy, which determines which RIP routes are accepted
in
as valid routes. This policy can be combined with the trusted neighbor policy to accept selected routes
only from a set of trusted neighbors.
Use the option to configure an output route policy, which determines which RIP routes are
out
advertised on the VLAN.
Example
The following command configures the VLAN backbone to accept selected routes from the policy nosales:
configure rip vlan backbone route-policy in nosales
The following command uses the policy nosales to determine which RIP routes are advertised into the
VLAN backbone:
configure rip vlan backbone route-policy out nosales
History
This command was first available in ExtremeWare XOS 10.1.
1220
Specifies a VLAN name.
Specifies all VLANs.
Specifies a policy.
Removes any policy from the VLAN.
ExtremeWare XOS 11.3 Command Reference