OSPFv3 Commands
unconfigure ospfv3
unconfigure ospfv3 {domain <domainName>} {area <area-identifier> | vlan
<vlan-name> | tunnel <tunnel-name>}
Description
Resets one or all OSPFv3 interfaces to the default settings.
Syntax Description
domainName
area-identifier
vlan-name
tunnel-name
Default
N/A.
Usage Guidelines
ExtremeWare XOS OSPFv3 allows you to change certain configurable OSPFv3 parameters on the fly.
This command selectively resets the configurable parameters to their default values. The following is
the list of parameters whose values will be reset to their defaults:
Interface
●
Hello Interval
■
Dead Interval
■
Transmit Delay
■
Retransmit Interval
■
Priority
■
Cost
■
Area
●
All the parameters of Interfaces associated with this area
■
Inter-Area-Prefix-LSA Filter
■
AS-External-LSA Filter
■
OSPF Global
●
All parameters of all areas in this OSPF domain
■
SPF Delay interval
■
1406
Specifies an OSPFv3 domain. OSPF-Default is the only one currently
supported.
Specifies an OSPFv3 area, a four-byte, dotted decimal number.
Specifies an IPv6 configured VLAN.
Specifies an IPv6 tunnel.
ExtremeWare XOS 11.3 Command Reference