Configure Bgp Neighbor Maximum-Prefix - Extreme Networks ExtremeWare XOS Command Reference Manual

BGP Commands

configure bgp neighbor maximum-prefix

configure bgp neighbor [<remoteaddr> | all] {address-family [ipv4-unicast |
ipv4-multicast]} maximum-prefix <number> {{threshold <percent>} {teardown
{holddown-interval <seconds>}} {send-traps}
Description
Configures the maximum number of IP prefixes accepted from a BGP neighbor.
Syntax Description
remoteaddr
all
address-family
number
percent
teardown
seconds
send-traps
Default
This feature is disabled by default.
The default threshold is 75%.
By default,
teardown
By default,
send-traps
If no address family is specified, IPv4 unicast is the default.
Usage Guidelines
Configure the peer group before configuring the neighbors. To configure the peer group, use the
following command:
configure bgp peer-group maximum-prefix
1434
Specifies an IP address of a BGP neighbor.
Specifies all neighbors.
The address family. BGP supports two address families: IPv4 Unicast and IPv4
Multicast.
Specifies the maximum number of prefixes that can be accepted. The range is
0 to 4294967294. A value of 0 disables prefix limit feature.
Specifies the percentage of the maximum prefix (threshold) at which a warning
message is printed in the log (and console), and/or a trap will be sent to the
SNMP manager.
Specifies that the peer session is torn down when the maximum is exceeded.
Specifies the length of time before the session is re-established, if the session
is torn down due to maximum prefix exceeded. If the hold-down interval is zero
or not specified, it is kept down until the peer is enabled. The range is 30 to
86400 seconds.
Specifies sending "number of prefix reached threshold" and "number of prefix
exceed the max-prefix limit" SNMP traps.
is not specified.
is not specified.
ExtremeWare XOS 11.3 Command Reference