Create Bgp Neighbor Peer-Group - Extreme Networks ExtremeWare XOS Command Reference Manual

Version 11.3

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

BGP Commands

create bgp neighbor peer-group

create bgp neighbor <remoteaddr> peer-group <peer-group-name> {multi-hop}

Creates a new neighbor and makes it part of the peer group.

Syntax Description

peer-group-name

Usage Guidelines

All the parameters of the neighbor are inherited from the peer group. The peer group should have the

remote AS configured.

To add an existing neighbor to a peer group, use the following command:

configure bgp neighbor [all | <remoteaddr>] peer-group [<peer-group-name> | none]

{acquire-all}

If you do not specify acquire-all, only the mandatory parameters are inherited from the peer group. If

you specify acquire-all, all of the parameters of the peer group are inherited. This command disables the

neighbor before adding it to the peer group.

The following command creates a new neighbor and makes it part of the peer group outer:

create bgp neighbor 192.1.1.22 peer-group outer

This command was first available in ExtremeWare XOS 10.1.

This command required an Advanced Core license in ExtremeWare XOS 11.1.

Platform Availability

This command is available on platforms with a Core or an Advanced Core license.

Specifies an IP address of the BGP neighbor.

Specifies a peer group.

Specifies to allow connections to EBGP peers that are not directly connected.

ExtremeWare XOS 11.3 Command Reference

Extremeware xos 11.3