Configure Iproute Add - Extreme Networks ExtremeWare XOS Command Reference Manual

IP Unicast Commands

configure iproute add

configure iproute add [<ipNetmask> | <ip_addr> <mask>] <gateway> <metric>
{vr <vrname>} {multicast-only | unicast-only}
Description
Adds a static route to the routing table.
Syntax Description
ipNetmask
ip_address
mask
gateway
metric
vrname
multicast-only
unicast-only
Default
If you do not specify a virtual router, the current virtual router context is used.
Usage Guidelines
Use a value of 255.255.255.255 for mask to indicate a host entry.
Example
The following command adds a static address to the routing table:
configure iproute add 10.1.1.0/24 123.45.67.1 5
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
1084
Specifies an IP address/mask length.
Specifies an IP address.
Specifies a subnet mask.
Specifies a VLAN gateway.
Specifies a cost metric.
Specifies the virtual router to which the route is added.
Specifies only multicast traffic for the route.
Specifies only unicast traffic for the route.
ExtremeWare XOS 11.3 Command Reference