Configure Bootprelay Dhcp-Agent Information Option - Extreme Networks ExtremeWare XOS Command Reference Manual

configure bootprelay dhcp-agent information option

configure bootprelay dhcp-agent information option
Description
Enables the Dynamic Host Configuration Protocol (DHCP) relay agent option (option 82).
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
After IP unicast routing has been configured, you can configure the switch to forward DHCP or BOOTP
requests coming from clients on subnets being serviced by the switch and going to hosts on different
subnets.
To configure the relay function, follow these steps:
1 Configure VLANs and IP unicast routing.
2 Enable the DHCP or BOOTP relay function, using the following command:
enable bootprelay {vr <vrid>}
3 Configure the addresses to which DHCP or BOOTP requests should be directed, using the following
command:
configure bootprelay add <ip_address> {vr <vrid>}
4 Configure the DHCP relay agent option (option 82), using the following command:
configure bootprelay dhcp-agent information option
To disable the DHCP relay agent option (option 82), use the following command:
unconfigure bootprelay dhcp-agent information option
Example
The following command configures the DHCP relay agent option:
configure bootprelay dhcp-agent information option
History
This command was first available in ExtremeWare XOS 11.1.
ExtremeWare XOS 11.3 Command Reference
configure bootprelay dhcp-agent information option
1071