BGP Commands
configure bgp neighbor password
configure bgp neighbor [all | <remoteaddr>] password [none | <tcpPassword>]
Description
Configures an MD5 secret password for a neighbor.
Syntax Description
all
remoteaddr
none
tcpPassword
Default
N/A.
Usage Guidelines
Disable the BGP neighbor or the BGP protocol before changing the password.
When a password is configured, TCP MD5 authentication is enabled on the TCP connection that is
established with the neighbor.
Changes made to the parameters of a peer group are applied to all neighbors in the peer group.
To change any one of the following parameters you must disable and re-enable the peer session:
timer
●
source-interface
●
soft-in-reset
●
password
●
Changing a route reflector client will automatically disable and enable the peer session.
Example
The following command configures the password for a neighbor as Extreme:
configure bgp neighbor 192.168.1.5 password extreme
History
This command was first available in ExtremeWare XOS 10.1.
This command required an Advanced Core license in ExtremeWare XOS 11.1.
1438
Specifies all neighbors.
Specifies an IP address of a BGP neighbor.
Specifies not to use a password
Specifies a password string.
ExtremeWare XOS 11.3 Command Reference