Extreme Networks ExtremeWare XOS Command Reference Manual page 1098

IP Unicast Commands
entry two {
if match all {
destination-port 67 ;
} then {
vlan "to7" ;
}
}
If you include more than one VLAN set attribute or more than one destination-ipaddress set attribute in
one policy entry, the last one will be accepted and the rest ignored. Therefore, you can have two valid
set statements in each entry of a UDP forwarding policy; one a destination-ipaddress and one a VLAN.
ExtremeWare XOS currently allows a maximum of eight entries in a UDP forwarding policy, so you can
define a maximum of sixteen destinations for one inbound broadcast UDP packet: eight IP address and
eight VLANs.
NOTE
It is strongly advised not to have more than eight entries in a UDP forwarding profile. The UDP forwarding module
will process those entries even if the entries do not contain any attributes for UDP forwarding. Having more than
eight entries will drastically reduce the performance of the system. If the inbound UDP traffic rate is very high,
having more than eight entries could cause the system to freeze or become locked.
NOTE
If you rename a VLAN referred to in your UDP forwarding profile, you must manually edit the policy to reflect the
new name, and refresh the policy.
You can also validate whether the UDP profile has been successfully associated with the VLAN by
using the command
part of the netTools process, so the command will display netTools as a user of the policy.
Example
The following command associates the UDP forwarding profile port123_to_corporate to the VLAN to-
sales:
configure vlan to-sales udp-profile port123_to_corporate
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
1098
show policy {<policy-name> | detail}
. UDP forwarding is implemented as
ExtremeWare XOS 11.3 Command Reference