Configure Ospfv3 Area Add Range - Extreme Networks ExtremeWare XOS Command Reference Manual

Version 11.3

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

configure ospfv3 area add range

configure ospfv3 {domain <domainName>} area <area-identifier> add range

<ipv6netmask> [advertise | noadvert] inter-prefix

Configures a range of IP addresses in an OSPFv3 area to be aggregated.

Syntax Description

area-identifier

inter-prefix

No OSPFv3 inter-area-prefix LSAs are configured.

Usage Guidelines

If advertised, the aggregated IP range is exported as a single LSA by the ABR.

The following command is used to summarize a certain range of IP addresses within an area and export

them out as a single address to area 0.0.0.1:

configure ospfv3 area 0.0.0.1 add range 2aaa:

This command was first available in ExtremeWare XOS 11.2

Platform Availability

This command is available on platforms with a Core or an Advanced Core license.

ExtremeWare XOS 11.3 Command Reference

Specifies an OSPFv3 domain. OSPF-Default is the only one currently

Specifies an OSPFv3 area, a four-byte, dotted decimal number.

Specifies an IPv6 address / prefix length.

Specifies to advertise the aggregated range of IP addresses.

Specifies not to advertise the aggregated range of IP addresses.

Specifies aggregate, inter-area-prefix LSAs.

456:3ffe::/64

configure ospfv3 area add range

advertise inter-prefix

Extremeware xos 11.3