Show Iproute - Extreme Networks ExtremeWare XOS Command Reference Manual

IP Unicast Commands

show iproute

show iproute {ipv4} {priority | vlan <vlan_name> | permanent | <ip_address>
<netmask> | summary} {multicast | unicast} {vr <vrname>}}
Description
Displays the contents of the IP routing table or the route origin priority.
Syntax Description
priority
vlan_name
permanent
ip_address
netmask
Default
N/A.
Usage Guidelines
If a route is active and in use, it is preceded in the display by an "*". If there are multiple routes to the
same destination network, the "*" will indicate which route is the most preferable route.
If you do not specify a virtual router, the command applies to the current virtual router.
Example
The following command displays detailed information about all IP routing:
show iproute
History
This command was first available in ExtremeWare XOS 10.1.
The ipv4 keyword was added in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
1148
Specifies a route priority.
Specifies a VLAN name.
Specifies permanent routing.
Specifies an IP address.
Specifies a subnet mask.
ExtremeWare XOS 11.3 Command Reference