Enable Ripng Originate-Default - Extreme Networks ExtremeWare XOS Command Reference Manual

RIPng Commands

enable ripng originate-default

enable ripng originate-default {always} cost <metric> {tag <number>}
Description
Configures a default route to be advertised by RIPng.
Syntax Description
always
cost <metric>
tag <number>
Default
Disabled.
Usage Guidelines
If is specified, RIPng always advertises the default route to its neighbors. If always is not
always
specified, RIPng advertises a default route only if a reachable default route is in the system route table
(the route is learned from other neighbors).
The default route advertisement is filtered using the out policy. Use the command,
route-policy
The cost metric is inserted for all RIPng-learned, static, and direct routes injected into RIPng. The tag
value is used only by special routing applications.
Example
The following command configures a default route to be advertised by RIPng if there is a default route
in the system routing table:
enable ripng originate-default cost 7
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
1270
Specifies to advertise the default route in addition to learned default route.
Specifies a cost metric. The range is 1 - 15.
Specifies a tag number.
, to specify the out policy.
configure ripng
ExtremeWare XOS 11.3 Command Reference