Configure Iproute Add Blackhole - Extreme Networks ExtremeWare XOS Command Reference Manual

configure iproute add blackhole

configure iproute add blackhole [<ipNetmask> | <ipaddress> <mask>] {vr
<vrname>} {multicast-only | unicast-only}
Description
Adds a blackhole address to the routing table. All traffic destined for a configured blackhole IP address
is silently dropped, and no Internet Control Message Protocol (ICMP) message is generated.
Syntax Description
ipNetmask
ipaddress
mask
vrname
multicast-only
unicast-only
Default
If you do not specify a virtual router, the current virtual router context is used.
Usage Guidelines
A blackhole entry configures packets with the specified destination IP subnet to be discarded. Blackhole
entries are useful as a security measure or in special circumstances where a specific destination IP
subnet must be discarded. Blackhole entries are treated like permanent entries in the event of a switch
reset or power off/on cycle.
Example
The following command adds a blackhole address to the routing table for packets with a destination
address of 100.101.145.4:
configure iproute add blackhole 100.101.145.4/32
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.3 Command Reference
Specifies an IP address/mask length.
Specifies an IP address.
Specifies a subnet mask.
Specifies the virtual router to which the route is added.
Specifies only multicast traffic for the route.
Specifies only unicast traffic for the route.
configure iproute add blackhole
1085