Configure Bgp Neighbor No-Dampening - Extreme Networks ExtremeWare XOS Command Reference Manual

configure bgp neighbor no-dampening

configure bgp neighbor [<remoteaddr> | all] {address-family [ipv4-unicast |
ipv4-multicast]} no-dampening
Description
Configures no route flap dampening over BGP peer sessions (disables route flap dampening).
Syntax Description
remoteaddr
all
address-family
Default
This feature is disabled by default.
If no address family is specified, IPv4 unicast is the default.
Usage Guidelines
Use the following command to enable route flap dampening for BGP neighbors:
configure bgp neighbor [all | <remoteaddr>] {address-family [ipv4-unicast | ipv4-
multicast]} dampening {{half-life <half-life-minutes> {reuse-limit <reuse-limit-
number> suppress-limit <suppress-limit-number> max-suppress <max-suppress-minutes>} |
policy-filter [<policy-name> | none]}
Example
The following command disables route flap dampening to the BGP neighbor at 192.168.1.22:
configure bgp neighbor 192.168.1.22 no-dampening
History
This command was first available in ExtremeWare XOS 10.1.
This command required an Advanced Core license in ExtremeWare XOS 11.1.
Platform Availability
This command is available on platforms with a Core or an Advanced Core license.
ExtremeWare XOS 11.3 Command Reference
Specifies an IP address of a BGP neighbor.
Specifies all neighbors.
The address family. BGP supports two address families: IPv4 Unicast and IPv4
Multicast.
configure bgp neighbor no-dampening
1437