Configure Iproute Add - Extreme Networks ExtremeWare XOS Command Reference Manual

configure iproute add

configure iproute add <ipv6Netmask> [<ipv6Gateway> | <ipv6ScopedGateway>]
{<metric>} {vr <vrname>} {multicast-only | unicast-only}
Description
Adds an IPv6 static route to the routing table.
Syntax Description
ipv6Netmask
ipv6Gateway
ipv6ScopedGateway
metric
vrname
multicast-only
unicast-only
Default
If you do not specify a virtual router, the current virtual router context is used. If you do not specify a
metric, then the default metric of 1 is used.
Usage Guidelines
Use a prefix length of 128 to indicate a host entry.
Example
The following command adds a static route to the routing table:
configure iproute add 2001:db8:0:1111::/64 fe80::1111
History
This command was first available in ExtremeWare XOS 10.1.
Support for IPv6 was added in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.3 Command Reference
Specifies an IPv6 address/prefix length.
Specifies a gateway.
Specifies a scoped gateway.
Specifies a cost metric.
Specifies the virtual router to which the route is added.
Specifies only multicast traffic for the route.
Specifies only unicast traffic for the route.
configure iproute add
1163