Show Iproute - Extreme Networks ExtremeWare Command Reference Manual

IP Unicast Commands

show iproute

show iproute {priority | vlan <vlan name> | permanent | <ip address>
<netmask> | route-map |origin [direct | static | blackhole | rip | bootp |
icmp | ospf-intra | ospf-inter | ospf-as-external | ospf-extern1 |
ospf-extern2]} {mpls} {sorted}
Description
Displays the contents of the IP routing table or the route origin priority.
Syntax Description
priority
vlan name
permanent
ip address
netmask
route-map
origin
mpls
sorted
Default
N/A.
Usage Guidelines
Route maps for IP routing can be configured based on the route origin. When routes are added to the IP
routing table from various sources, the route map configured for the origin of the route is applied to the
route. After matching on specified characteristics, the characteristics for the route can be modified using
the route maps. The characteristics that can be matched and modified are dependent on the origin of the
route. Route maps for IP routing can be dynamically changed. In the case of direct and static route
origins, the changes are reflected immediately. In the case of routes that are sourced from other origin,
the changes are reflected within 30 seconds.
The output of the
show iproute
LSPs associated with the routes. The flags field displayed by this command has been enhanced to
indicate the presence of MPLS next hops. An uppercase
hop for the route. A lowercase
An optional keyword has been added to the
mpls
specified, the information displayed is modified; some of the information normally displayed is
omitted, and the LSP endpoint and outgoing MPLS label are displayed instead. The LSP endpoint is the
IP address/prefix of the FEC associated with the LSP. The LSP endpoint matches the destination for
direct LSPs and is a 32-bit prefix address of a proxy router for indirect LSPs.
1244
Specifies a route priority.
Specifies a VLAN name.
Specifies permanent routing.
Specifies an IP address.
Specifies a subnet mask.
Specifies display of route maps for direct, static, blackhole, RIP, BOOTP,
ICMP, OSPF-intra, OSPF-inter, OSPF as External, OSPF External 1, and
OPPF External 2 routing.
Specifies a display of the route map origin.
Specifies to display MPLS information.
Specifies to sort the information displayed.
command has been enhanced to include information about MPLS
indicates the presence of an indirect LSP next hope for the route.
l
show iproute
indicates the presence of a direct LSP next
L
command. When the
ExtremeWare Software 7.3.0 Command Reference Guide
keyword is
mpls