Zone Default-Zone - Cisco MDS 9124 - Fabric Switch Reference

zone default-zone

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
zone default-zone
To define whether a default zone (nodes not assigned a created zone) permits or denies access to all in
the default zone, use the zone default-zone command in configuration mode. Use the no form of the
command to negate the command or revert to the factory defaults.
Syntax Description permit
vsan vsan-id
Defaults
All default zones are permitted access.
Command Modes Configuration mode.
Command History Release
1.0(2)
Usage Guidelines
Use the zone default-zone permit vsan command to define the operational values for the default zone
in a VSAN. This command applies to existing VSANs; it has no effect on VSANs that have not yet been
created.
Use the system default zone default-zone permit command to use the default values defined for the
default zone for all VSANs. The default values are used when you initially create a VSAN and it
becomes active.
Examples The following example permits default zoning in VSAN 2.
switch# config terminal
switch(config)# zone default-zone permit vsan 2
Related Commands Command
system default zone
default-zone permit
show zone
Cisco MDS 9000 Family Command Reference
27-8
zone default-zone [permit] vsan vsan-id
no zone default-zone [permit] vsan vsan-id
Permits access to all in the default zone.
Sets default zoning behavior for the specified VSAN. The ID of the VSAN
is from 1 to 4093.
Modification
This command was introduced.
Description
Configures default values for a zone.
Displays zone information.
Chapter 27
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Z Commands