Lacp System-Priority - Cisco Catalyst 3550 Command Reference Manual

lacp system-priority

lacp system-priority
Use the lacp system-priority global configuration command to set the system priority for Link
Aggregration Control Protocol (LACP). Use the no form of this command to return to the default setting.
Syntax Description
priority-value
Defaults The default priority value is 32768.
Command Modes
Global configuration
Command History Release
12.1(12c)EA1
Usage Guidelines
Although this is a global configuration command, the priority only takes effect on EtherChannels that
have physical interfaces with LACP enabled.
Note For more information about configuring LACP on physical interfaces, refer to the "Configuring
EtherChannels" chapter in the software configuration guide for this release.
Examples
This example shows how to set the system priority for LACP:
Switch(config)# lacp system-priority 32764
You can verify your settings by entering the show lacp internal privileged EXEC command.
Related Commands Command
lacp port-priority
Catalyst 3550 Multilayer Switch Command Reference
2-134
lacp system-priority priority-value
no lacp system-priority
System priority for LACP. The range is from 1 to 65535.
Modification
This command was first introduced.
Description
Sets the LACP priority for a specific port.
Chapter 2 Cisco IOS Commands
78-11195-09