Configuring A Cpos Interface - 3Com MSR 50 Series Configuration Manual

544 C 29: CPOS I
HAPTER
Configuring a CPOS
Interface
C
NTERFACE ONFIGURATION
Figure 154 A CPOS implementation
N x 64 kbps
Follow these steps to configure a CPOS interface:
To do...
Enter system view
Enter CPOS interface view
Set the framing format
Set the clock mode
Set the loopback mode
Configure the AUG
multiplexing mode
Configuring the SOH and
higher-order path overhead
bytes
Configure E1 or T1 channel
attributes
Transmission
network
N x 2 Mbps
E1
Access
network
N x 64 kbps
N x 64 kbps
Use the command...
system-view
controller cpos cpos-number Required
frame-format { sdh | sonet } Optional
clock { master | slave }
loopback { local | remote }
multiplex mode { au-3 |
au-4 }
flag { j0 j0-string | j1 j1-string
| c2 c2-value }
See "CPOS Interface
Configuration" on page
Internet
Router A
Remarks
--
The default is SDH.
Optional
The default is slave.
Optional
Disabled by default
Optional
Available only in SDH framing.
The default is AU-4.
Optional
The following are the
defaults:
Cyclic sending of hexadecimal
01 for J0 for backward
compatibility.
Cyclic sending of the
character string NetEngine for
J1.
Hexadecimal 02 for C2.
Optional
539.