Running And Terminating Ttyd On Unix Server; Editing The Ttyd Configuration File; Modifying Route Configuration File; Installing And Using Ttyd Administration Program Ttyadm - 3Com MSR 50 Series Configuration Manual

Editing the ttyd
Configuration File
Modifying Route
Configuration File
Running and
Terminating ttyd on
Unix Server
Installing and Using ttyd
Administration Program
ttyadm
/root/ttydp/ttyd /root/ttydp/tty9000.conf
/root/ttydp/ttyd /root/ttydp/tty9001.conf
sleep 10
last=0
for i in 'LC_ALL=C grep '^[0-9]*.*respawn:/sbin/mingetty' /etc/initt
ab | sed 's/
^.* tty([0-9][0-9]*).*/1/g''; do
......
Refer to "Editing the ttyd Configuration File" on page
The terminal access router is usually connected to the Unix server through WANs
and therefore located on an IP segment different from that of the Unix server, in
which case you must configure a route on the Unix server.
The following example shows how to do so:
# route add net 10.110.96.0 netmask 255.255.255.0 63.1.1.250
In the example above, 10.110.96.0 is the destination subnet, with the subnet
mask of 255.255.255.0 and the gateway (a router) IP address of 63.1.1.250.
Running ttyd
Refer to "Running ttyd" on page
Terminating ttyd
Refer to "Terminating ttyd" on page
Refer to "Installing and Using ttyd Administration Program ttyadm" on page
Installing and Configuring Red Hat Linux Server
775.
778.
779.
797
780.