Entering Aggregation Port Group View; Displaying And Maintaining Link Aggregation; Link Aggregation Configuration Example - 3Com MSR 50 Series Configuration Manual

Entering Aggregation
Port Group View
Displaying and
Maintaining Link
Aggregation
Link Aggregation
Configuration
Example
To do...
Enter system view
Assign a name for an
aggregation group
In aggregation port group view, you can make configuration for all the member
ports in a link aggregation group at one time.
Follow these steps to enter aggregation port group view:
To do...
Enter system view
Enter aggregation port group
view
c
CAUTION: In aggregation port group view, you can configure aggregation related
settings such as STP, VLAN, QoS, GVRP, MAC address learning, but cannot add or
remove member ports.
To do...
Display the local system ID
Display detailed information
about link aggregation for
the specified port or ports
Display summaries for all link
aggregation groups
Display detailed information
about specified or all link
aggregation groups
Clear the statistics about
LACP for specified or all ports
Network requirements
Device A aggregates ports Ethernet 1/1 through Ethernet 1/3 to form one link
connected to Device B and performs load sharing among these ports.
Create an IPv6 service-loop group and assign port Ethernet 1/1 to the group.

Displaying and Maintaining Link Aggregation

Use the command...
system-view
link-aggregation group
agg-id description agg-name
Use the command...
system-view
port-group aggregation agg-id
Use the command...
display lacp system-id
display link-aggregation interface
interface-type interface-number [ to
interface-type interface-number ]
display link-aggregation summary
display link-aggregation verbose
[ agg-id ]
reset lacp statistics [ interface
interface-type interface-number [ to
interface-type interface-number ] ]
353
Remarks
--
Required
None is configured by default.
Remarks
--
--
Remarks
Available in any
view
Available in any
view
Available in any
view
Available in any
view
Available in user
view