Configuring Rip-To-Mib Binding; Displaying And Maintaining Rip Configuration; Rip Configuration Example; Rip Version Configuration - 3Com MSR 50 Series Configuration Manual

986 C 59: RIP C
HAPTER
Configuring RIP-to-MIB
Binding
Displaying and
Maintaining RIP
Configuration
RIP Configuration
Example
RIP Version
Configuration
ONFIGURATION
To do...
Configure the upper limit for
retransmitting an Update
Request or Update Response
The maximum retransmission time (upper limit × interval) for a packet cannot be
n
too long lest when its neighbor is down, the router still resends the packet.
Follow these steps to bind RIP to MIB:
To do...
Enter system view
Bind RIP to MIB
To do...
Display RIP current status and
configuration information
Display all active routes in RIP
database
Display RIP interface
information
Display routing information
about a specified RIP process
Clear the statistics of a RIP
process
Network requirements
As shown in Figure
Network diagram
Figure 298 Network diagram for RIP version configuration
Eth1/1
2.1.1.1/24
Router A
Use the command...
trip retransmit count
retransmit-count-value
Use the command...
system-view
rip mib-binding process-id Optional
Use the command...
display rip [ process-id | vpn-instance
vpn-instance-name ]
display rip process-id database
display rip process-id interface
[ interface-type interface-number ]
display rip process-id route [ statistics |
ip-address { mask | mask-length } | peer
ip-address ]
reset rip process-id statistics
298, enable RIP-2 on all interfaces on Router A and Router B.
RIP 100
Eth1 /0
1 .1.1.1/24
Eth1/0
1.1 .1.2/24
Router B
Remarks
Optional
36 by default
Remarks
--
By default, MIB is bound to the RIP
process with the smallest process ID
Remarks
Available in any
view
Available in user
view
RIP 200
Eth1 /1
3 .1.1.1/24
Eth1/0
3.1 .1.2/24
Router C
Eth1/2
5.1.1.1 /24
Eth1/1
4.1.1 .1/24