Configuring A Ce3 Interface Operating In Ce3 Mode; Configuring Other Ce3 Interface Parameters - 3Com MSR 50 Series Configuration Manual

120 C 4: WAN I
HAPTER NTERFACE
Configuring a CE3
Interface operating in
CE3 Mode
Configuring Other CE3
Interface Parameters
C
ONFIGURATION
To do...
Enter CE3 interface view
Set the interface to operate in
E3 mode
Configure the interface to
operate in FE3 mode and set
the DSU mode or the subrate
Set other interface parameters See
Depending on the networking requirements, you probably need to configure the
CE3 interface with parameters about
Configuration" on page
on.
Follow these steps to configure a CE3 interface in CE3 mode:
To do...
Enter system view
Enter CE3 interface view
Set the interface to operate in CE3
mode
Set the Set the operating
operating mode to unframed
mode of an E1 (E1) mode
line on the
Set the operating
CE3 interface
mode to framed
to unframed
(CE1) mode and
mode or
bundle timeslots
framed mode
on the CE1
interface
Set other interface parameters
Depending on the networking requirements, you probably need to configure the
CE3 interface with parameters about
Configuration" on page
on.
Follow these steps to configure other CE3 interface parameters:
To do...
Enter system view
Use the command...
controller e3
interface-number
using e3
fe3 { dsu-mode { 0 | 1 } |
subrate number }
"Configuring Other CE3
Interface Parameters" on
page 120.
"Configuring PPP" on page
2385, "IP Addressing Configuration" on page
Use the command...
system-view
controller e3
interface-number
using ce3
e1 line-number
unframed
undo e1 line-number
unframed
e1 line-number
channel-set set-number
timeslot-list list
See "Configuring Other
CE3 Interface
Parameters" on page
120.
"Configuring PPP" on page
2385, "IP Addressing Configuration" on page
Use the command...
system-view
Remarks
Required
Required
The default operating mode is
CE3 mode.
Optional
By default, DSU mode 1 (the
Kentrox mode) is adopted,
and the subrate is 34010
kbps.
Optional
367, "VoFR
623, and so
Remarks
--
Required
Optional
The default operating mode is
CE3 mode.
Required
The default is CE1 mode.
Optional
The default is framed mode.
Required
No channel sets are created
by default.
Optional
367, "VoFR
623, and so
Remarks
--