Configuring Trip - 3Com MSR 50 Series Configuration Manual

To do...
Disable source address check
on received RIP update
messages
n
You need not use the peer ip-address command when the neighbor is directly
connected; otherwise the neighbor may receive both the unicast and multicast (or
broadcast) of the same routing information.

Configuring TRIP

In a connection oriented network, a router may establish connections to multiple
remote devices. In a WAN, links are created and removed as needed. In such
applications, a link created between two nodes for data transmission is temporary
and infrequently.
TRIP should be enabled when it is necessary to exchange routing information via
on-demand links or triggered RIP.
Enable TRIP
Follow these steps to enable TRIP:
To do...
Enter system view
Enable RIP
Return to system view
Enter interface view
Enable TRIP
n
If RIP is disabled, TRIP is also disabled.
Configure TRIP retransmission parameters
You can specify intervals and upper limits for Update Request and Response
retransmissions as needed.
For two routers on an analog dial-up link, the difference between retransmission
intervals on the two ends must be bigger than 50 seconds; otherwise, they can
not become TRIP neighbors.
Follow these steps to configure TRIP retransmission parameters:
To do...
Enter system view
Enable RIP and enter its view
Configure the interval for
retransmitting an Update
Request or Update Response
Optimizing the RIP Network
Use the command...
undo validate-source-address Required
Use the command...
system-view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
quit
interface interface-type
interface-number
rip triggered
Use the command...
system-view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
trip retransmit timer
retransmit-time-value
985
Remarks
Not disabled by default
Remarks
--
Required
--
--
Required
Disabled by default.
Remarks
-
Required
Required
5 seconds by default