Configuring Pppoe Client; Introduction To Pppoe Client - 3Com MSR 50 Series Configuration Manual

Configuring PPPoE
Client
Introduction to PPPoE
Client
To do...
Enter system view
Create VT and enter its view
Configure PPP parameters
(including authentication type, IP
address negotiation, etc)
Enter the specified Ethernet
interface
Enable PPPoE on Ethernet
interface
Exit to system view
Configure the maximum number
of PPPoE sessions that can be
created on a remote MAC
address
Configure the maximum number
of PPPoE sessions that can be
created on a local MAC address
Configure the maximum number
of PPPoE sessions that can be
created on the system
Configure authentication and
accounting on PPP users
Exit to system view
Disable PPPoE Server to produce
PPP log information
n
For a virtual template interface, if a static route is used, you are recommended to
specify the next hop rather than the outgoing interface. If the outgoing interface
must be specified, make sure that the physical interface bound in the virtual
template is effective to ensure normal transport of packets.
PPPoE client configuration tasks include dialer interface configuration and PPPoE
session configuration.
Before configuring PPPoE session, you should first configure a dialer interface and
configure a dialer bundle on the interface. Each PPPoE session uniquely
corresponds to a dialer bundle and each dialer bundle uniquely corresponds to a
dialer interface. Thus, a PPPoE session can be created via a dialer interface.
PPPoE session can be configured on a physical Ethernet interface or a virtual
Ethernet (VE) interface created on an ADSL interface. When a device is connecting
to the Internet through an ADSL interface, it is necessary to configure PPPoE
session on the virtual Ethernet interface; when a device is connecting to an ADSL
Modem and then the Internet via an Ethernet interface, it is necessary to configure
the PPPoE session on the Ethernet interface.

Configuring PPPoE Client

Use the command...
system-view
interface virtual-template
number
Refer to "Configuring PPP" on
page 367
interface ethernet
interface-number
pppoe-server bind
virtual-template number
quit
pppoe-server max-sessions
remote-mac number
pppoe-server max-sessions
local-mac number
pppoe-server max-sessions
total number
For detailed information, refer to
"AAA for PPP Users by a
HWTACACS Server" on page
quit
pppoe-server log-information
off
395
Remarks
-
-
Optional
Required
Required
Disabled by default
-
Optional
100 by default
Optional
100 by default
Optional
4096 by default
Optional
1784.
-
Optional
Enabled by default