Configuring Ipoeoa; Configuring Pppoa - 3Com MSR 50 Series Configuration Manual

Configuring IPoEoA

Configuring PPPoA

Note that a PVC cannot carry multiple protocols when the ATM AAL5 is
encapsulated with aal5mux. Once IPoA is configured on the PVC, other protocols
such as IPoEoA, PPPoA and PPPoEoA are not supported.
Follow these steps to enable IPoEoA on PVC:
To do...
Enter system view
Create a virtual Ethernet (VE)
interface
Quit to system view
Enter ATM interface view
Create PVC, and enter its view pvc { pvc-name [ vpi/vci ] |
Configure IPoEoA mapping
on PVC
When two routers are connected using DSL interfaces through a dial-up
connection, configure them as PPPoA server and client respectively. The two are
different in that, with the PPPoE server, you should configure an address pool to
allocate IP address for the remote node; with the PPPoE client, you should
configure address negotiation to accept the IP address allocated by the server end.
For relevant information, refer to
The following configurations enable the PVC to carry PPP and configure a PPP
mapping for the PVC.
Note that a PVC cannot carry multiple protocols when the ATM AAL5 is
encapsulated with aal5mux. Once PPPoA is configured on the PVC, other
protocols such as IPoA, IPoEoA, and PPPoEoA are not supported.
Follow these steps to configure PPPoA:
To do...
Enter system view
Create a VT interface
Configuring Applications over ATM
Use the command...
system-view
interface virtual-ethernet
interface-number
quit
interface atm
{ interface-number |
interface-number.subnumber
}
vpi/vci }
map bridge
virtual-ethernet
interface-number
"PPP and MP Configuration" on page 363
Use the command...
system-view
interface
virtual-template
vt-number
137
Remarks
-
Required
The IP address has to be
configured on VE interface (It
is invalid to configure it on
ATM interface)
-
-
Required
Required
Remarks
-
Required
You must configure PPP
authentication and IP address
on the VT interface (the IP
address is invalid if configured
on the ATM interface).