Configuring The Root Bridge; Configuring An Mst Region - 3Com MSR 50 Series Configuration Manual

Configuring the Root
Bridge
Configuring an MST
Region
Task
"Configuring Leaf
Nodes" on page 470
"Performing mCheck" on page 474
"Configuring Digest Snooping" on page 475
"Configuring No Agreement Check" on page 477
"Configuring Protection Functions" on page 479
n
If both GVRP and MSTP are enabled on a device at the same time, GVRP packets
will be forwarded along the CIST. Therefore, if both GVRP and MSTP are running
on the same device and you wish to advertise a certain VLAN within the network
through GVRP, make sure that this VLAN is mapped to the CIST (instance 0) when
configuring the VLAN-to-instance mapping table. For detailed information of
GVRP, refer to "GVRP Configuration" on page
Configuration procedure
Follow these steps to configure an MST region:
To do...
Enter system view
Enter MST region view
Configure the MST region
name

"Configuring an MST Region"

on page 470
"Configuring the Work Mode of
MSTP" on page 470
"Configuring the Timeout
Factor" on page 470
"Configuring the Maximum
Transmission Rate of Ports" on
page 470
"Configuring Ports as Edge
Ports" on page 470
"Configuring Path Costs of
Ports" on page 470
"Configuring Port Priority" on
page 473
"Configuring Whether Ports
Connect to Point-to-Point Links"
on page 473
"Configuring the Mode a Port
Uses to Recognize/Send MSTP
Packets" on page 473
"Enabling the MSTP Feature" on
page 474
271.
Use the command...
system-view
stp region-configuration
region-name name

Configuring the Root Bridge

Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Required
Optional
Optional
Optional
Optional
Remarks
-
-
Optional
The MST region name is the
MAC address by default
459