3Com MSR 50 Series Configuration Manual page 297

To do...
Specify ROA (recognized
operating agency)
2 Address-mapping-based configuration
To do...
Enter system view
Define ROA (Recognized
operating Agency) list
Enter interface view
Specify CUG (Closed User
Group) number
Perform max packet
negotiation while initiating a
call
Perform window size
negotiation while initiating a
call
Request reverse charging
when initiating a call
Receive calls with reverse
charging requests
Request throughput-level
negotiation while initiating a
call
Carry transmission delay
request while initiating a call
Specify ROA (Recognized
operating Agency)
For CUG configuration, refer to
303.
Configure the data queue length of VC
You can specify the sending and receiving queue lengths of VC for X.25 to adapt
to different network environments. The default queue length can contain 200
packets, but you can increase the number for the sake of preventing accidental
packet loss in case of large traffic size or low X.25 network transmission rate.
To configure the queue length of VC, use the following commands:
Use the command...
x25 call-facility roa-list
name
Use the command...
system-view
x25 roa-list roa-name
roa-id&<1-10>
interface interface-type
interface-number
x25 map protocol-type
protocol-address x121-address
x.121-address closed-user-group
number
x25 map protocol-type
protocol-address x121-address
x.121-address packet-size
input-packet output-packet
x25 map protocol-type
protocol-address x121-address
x.121-address window-size
input-window-size
output-window-size
x25 map protocol-type
protocol-address x121-address
x.121-address
reverse-charge-request
x25 map protocol-type
protocol-address x121-address
x.121-address
reverse-charge-accept
x25 map protocol-type
protocol-address x121-address
x.121-address threshold in out
x25 map protocol-type
protocol-address x121-address
x.121-address send-delay
milliseconds
x25 map protocol-type
protocol-address x121-address
x.121-address roa-list name
"Configuring X.25 Closed User Group" on page
Configuring X.25 297
Remarks
Optional
Not configured by default
Remarks
-
Optional
Not defined by default
-
Optional
Not specified by default
Optional
Not configured by
default
Optional
Not configured by
default
Optional
Not configured by
default
Optional
Not configured by
default
Optional
Not configured by
default
Optional
Not configured by
default
Optional
Not configured by
default