Configuring A Ct3 Interface (In T3 Mode); Configuring Ct3 Interface In Ct3 Mode - 3Com MSR 50 Series Configuration Manual

Configuring a CT3
Interface (in T3 Mode)
Configuring CT3
Interface in CT3 Mode
number/line-number:set-number for it. This interface operates at N × 64 kbps or N
× 56 kbps and is logically equivalent to a synchronous serial interface where you
can make other configurations.
Follow these steps to configure a CT3 interface in CT3 mode:
To do...
Enter system view
Enter CT3 interface view
Set the interface to operate in
T3 mode
Configure the interface to
operate in the FT3 mode and
set the DSU mode or the
subrate
Set other interface parameters See
Depending on the networking requirements, you probably need to configure the
CT3 interface with parameters about
Configuration" on page
on.
Follow these steps to configure a CT3 interface in CT3 mode:
To do...
Enter system view
Enter CT3 interface view
Set the interface to operate in CT3
mode
Set the Set the operating
operating mode to unframed
mode of a T1 (T1) mode
line on the
Set the operating
CT3 interface
mode to framed
to unframed
(CT1) mode and
mode or
bundle timeslots
framed mode
on the CT1
interface
Set other interface parameters
Use the command...
system-view
controller t3
interface-number
using t3
ft3 { dsu-mode { 0 | 1 | 2 | 3 |
4 } | subrate number }
"Configuring Other CT3
Interface Parameters" on
page 124.
"Configuring PPP" on page
2385, "IP Addressing Configuration" on page 623
Use the command...
system-view
controller t3
interface-number
using ct3
t1 line-number
unframed
undo t1 line-number
unframed
t1 line-number
channel-set set-number
timeslot-list range
[ speed { 56k | 64k } ]
See "Configuring Other
CT3 Interface
Parameters" on page
124.
CT3 Interface 123
Remarks
--
Required
Required
The default operating mode is
CT3 mode.
Optional
By default, DSU mode 0 (the
digital link mode) is adopted,
and the subrate is 44210
kbps.
Optional
367, "VoFR
and so
Remarks
--
Required
Optional
The default operating mode is
CT3 mode.
Required
The default is CT1 mode.
Optional
The default is framed mode.
Required
No channel sets are created
by default.
The default timeslot speed is
64 kbps.
Optional