Configuring Ipv6 Bgp Soft Reset; Configuring The Maximum Number Of Load-Balanced Routes - 3Com MSR 50 Series Configuration Manual

1026 C 62: IP 6 BGP C
HAPTER V
n
Configuring IPv6 BGP
Soft Reset
n
Configuring the
Maximum Number of
Load-Balanced Routes
ONFIGURATION
Timers configured using the timer command have lower priority than timers
■
configured using the peer timer command.
The holdtime interval must be at least three times the keepalive interval.
■
Enable route refresh
Follow these steps to enable route refresh:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family
view
Enable route refresh
Perform manual soft-reset
Follow these steps to perform manual soft reset:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Save all routes from a peer/peer
group, not letting them go through
the inbound policy
Return to user view
Soft-reset BGP connections manually refresh bgp ipv6 { all |
If the peer keep-all-routes command is used, all routes from the peer/peer
group will be saved regardless of whether filtering policy available. These routes
will be used to generate IPv6 BGP routes after soft-reset is performed.
Follow these steps to configure the maximum number of load balanced routes:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view ipv6-family
Configure the maximum
number of load balanced
routes
Use the command...
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name | ipv6-address }
capability-advertise route-refresh
Use the command...
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address } keep-all-routes
return
ipv6-address | group
ipv6-group-name | external |
internal } { export | import }
Use the command...
system-view
bgp as-number
balance number
Remarks
-
Required
-
Optional
Enabled by default
Remarks
-
Required
-
Optional
Not saved by
default.
Required
Remarks
-
Required
-
Required
By default, no load balancing
is enabled.