Rs-Dcc Application With Mp - 3Com MSR 50 Series Configuration Manual

190 C 6: DCC C
HAPTER
RS-DCC Application with
ONFIGURATION
# Configure a dial access control rule for dialer access group 2; create a local user
account usera for Router A and configure PPP authentication for it.
<RouterC> system-view
[RouterC] dialer-rule 1 ip permit
[RouterC] local-user usera
[RouterC-luser-usera] password simple usera
[RouterC-luser-usera] service-type ppp
[RouterC-luser-usera] quit
# Assign an IP address to interface Dialer0, enable RS-DCC, and configure the
remote username allowed to call in.
[RouterC] interface dialer 0
[RouterC-Dialer0] ip address 122.1.1.2 255.255.255.0
[RouterC-Dialer0] dialer user usera
[RouterC-Dialer0] dialer bundle 1
# Configure information for PPP authentication and the dial strings on interface
Dialer0.
[RouterC-Dialer0] dialer-group 1
[RouterC-Dialer0] dialer number 8810048
[RouterC-Dialer0] ppp authentication-mode pap
[RouterC-Dialer0] ppp pap local-user userc password simple userc
[RouterC-Dialer0] quit
# Configure information for PPP authentication on interface BRI 1/0 and assign the
interface to dialer bundle 1.
[RouterC] interface bri 1/0
[RouterC-Bri1/0] dialer bundle-member 1
[RouterC-Bri1/0] link-protocol ppp
[RouterC-Bri1/0] ppp authentication-mode pap
[RouterC-Bri1/0] ppp pap local-user usera password simple usera
Network requirements
MP
Figure 26 presents a scenario where:
Two ISDN BRI interfaces on Router A and an ISDN PRI interface on Router B are
■
connected across ISDN.
Interface Dialer0 on Router A is assigned an IP address 100.1.1.1/24, and
■
interface Dialer0 on Router B is assigned an IP address 100.1.1.2/24.
Use RS-DCC on Router A to call Router B and C-DCC on Router B to call Router A.
In addition, implement traffic distribution for the two interfaces on Router A by
setting traffic thresholds and maximum bandwidth.