Ip Accounting Configuration Example; Network Requirements - 3Com MSR 50 Series Configuration Manual

620 C 39: IP A
HAPTER CCOUNTING
IP Accounting
Configuration
Example

Network Requirements

C
ONFIGURATION
To do...
Enter system view
Enable the IP accounting feature
Configure the aging time for an IP
accounting entry
Set the maximum number of IP
accounting entries in the interior table
Set the maximum number of entries in
the exterior table
Configure IP accounting rules
Enter interface view
Configure the Count incoming IP
type of packet packets on the
accounting current interface
Count outgoing IP
packets on the
current interface
Count firewall-denied
incoming packets on
the current interface
Count firewall-denied
outgoing packets on
the current interface
As shown in Figure 184, the router is connected to Host A and Host B through
Ethernet interfaces.
Enable IP accounting on Ethernet1/0 of the router to count the IP packets from
Host A to Host B, with the aging time for IP accounting entries being 24 hours.
Use the command...
system-view
ip count enable
ip count timeout
minutes
ip count
interior-threshold
number
ip count
exterior-threshold
number
ip count rule { mask |
mask-length }
interface interface-type
interface-number
ip count
inbound-packets
ip count
outbound-packets
ip count
firewall-denied
inbound-packets
ip count
firewall-denied
outbound-packets
Remarks
--
Required
Disabled by default.
Optional
720 minutes (namely, 12
hours) by default.
Optional
512 by default.
Optional
0 by default.
Required.
Up to 32 rules can be
configured.
If no rule is configured,
the current packets are
not concerned and are all
counted in the exterior
table.
--
Required
Select at least one type of
packet accounting.
Otherwise, no IP packets
are to be counted on the
current interface.