3Com MSR 50 Series Configuration Manual page 162

3com msr 30-16: software guide
Hide thumbs Also See for MSR 50 Series:
Table of Contents

Advertisement

162
C
6: DCC C
HAPTER
ONFIGURATION
To do...
Configure the interface to
receive calls from a remote
end
Configuring an interface to place calls to multiple remote ends
As shown in the following figure, an interface at the local end places calls to
multiple remote ends (the components in inverse color represent the routers
irrelevant to the networking):
Figure 17 Network diagram for an interface to place calls to multiple remote ends
if0
Local end
(Single
interface)
In this scenario, a single local interface interface0 (if0) places DCC calls to multiple
remote interfaces including if1 and if2. As multiple remote ends are involved, you
must use the dialer route command to configure the dialer strings and
destination addresses. As only one originating interface is involved, you may
configure DCC parameters for the interface by configuring a dialer circular group.
In addition, you may configure PAP or CHAP authentication.
After completing the basic DCC configurations, follow these steps to configure an
interface to place calls to multiple remote ends:
To do...
Enter system view
Enter dial interface (physical
or dialer) view
Enable C-DCC
Repeat this step to configure
the dial strings and
destination addresses for the
interface to place calls to
multiple remote ends
Use the command...
dialer route protocol
next-hop-address [ mask
network-mask-length ] [ user
hostname | broadcast ] *
Remote end A
if1
(Single/Multiple
interfaces)
Remote end B
if2
(Single/Multiple
interfaces)
if3
Remote end C
(Single/Multiple
interfaces)
Use the command...
system-view
interface interface-type
interface-number
dialer enable-circular
dialer route protocol
next-hop-address [ mask
network-mask-length ] [ user
hostname | broadcast ] * dial-number
[ autodial | interface interface-type
interface-number ] *
Remarks
Optional
If the dialer route ip
next-hop-address user
hostname command is
configured at the called end,
the called party will use the
specified next hop address
and hostname to authenticate
the calling party.
Remarks
--
--
Required
Disabled by default
Required

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents