Configuration Procedure - 3Com MSR 50 Series Configuration Manual

Configuration Procedure

n
c
Follow these steps to configure an IPv6 manually configured tunnel:
To do...
Enter system view
Enable the IPv6 packet forwarding
function
Create a tunnel interface and enter
tunnel interface view
Configure an Configure a global
IPv6 address unicast IPv6 address
for the tunnel or a site-local address
interface
Configure a link-local
IPv6 address
Configure the tunnel to be an IPv6
manually configured tunnel
Configure a source address or
interface for the tunnel
Configure a destination address for
the tunnel
Configure the MTU of IPv6 packets
sent over the tunnel interface
For the configuration of MTU of IPv6 packets sent over a tunnel interface, refer to
the ipv6 mtu command in
CAUTION:
After a tunnel interface is deleted, all the above features configured on the
■
tunnel interface will be deleted.
Configuring an IPv6 Manually Configured Tunnel
Use the command...
system-view
ipv6
interface tunnel number
ipv6 address
{ ipv6-address
prefix-length |
ipv6-address/prefix-length
}
ipv6 address
ipv6-address/prefix-length
eui-64
ipv6 address auto
link-local
ipv6 address ipv6-address
link-local
tunnel-protocol
ipv6-ipv4
source { ip-address |
interface-type
interface-number }
destination ip-address
ipv6 mtu mtu-size
"Configuring the Interface MTU" on page
701
Remarks
-
Required
By default, the IPv6
packet forwarding
function is disabled.
Required
By default, there is no
tunnel interface on the
device.
Required
Use any command.
By default, no IPv6 global
unicast address or
site-local address is
configured for the tunnel
interface.
Optional
A link-local address will
automatically be created
when an IPv6 global
unicast address or
site-local address is
configured.
Required
By default, the tunnel is a
GRE tunnel. The same
tunnel type should be
configured at both ends
of the tunnel. Otherwise,
packet delivery will fail.
Required
By default, no source
address or interface is
configured for the tunnel.
Required
By default, no destination
address is configured for
the tunnel.
Optional
The default value varies
with devices.
670.