Configuring Ppp - 3Com MSR 50 Series Configuration Manual

Configuring PPP

Configuring PPP
Increase bandwidth, or dynamically increase/reduce bandwidth in combination
■
with dial control center (DCC)
Load sharing
■
Backup
■
Decrease transmission delay through fragmentation
■
MP can work on any physical or virtual interfaces encapsulated with PPP, such as
serial, ISDN BRI/PRI, and PPPoX (PPPoE, PPPoA, or PPPoFR). However, a multilink
bundle is preferred to include only one type of interfaces.
Follow these steps to configure PPP:
To do...
Enter system view
Enter the specified interface view
Configure the link layer protocol
encapsulated on the interface as
PPP
Set the polling interval
Configure the Configure the
local device to local device to
authenticate the authenticate the
peer either PAP peer using PAP
or CHAP)
Configure the
local device to
authenticate the
peer using
CHAP
Configure the Configure the
local device to local device to
be be
authenticated by authenticated by
the peer (either the peer using
PAP or CHAP) PAP
Configure the
local device to
be
authenticated by
the peer using
CHAP
Configure PPP negotiation
parameters
Configure PPP link quality control
(LQC)
Enable the PPP accounting
statistics function
Use the command...
system-view
interface interface-type
interface-number
link-protocol ppp
timer hold seconds
Refer to "Configuring the
Local Device to
Authenticate the Peer
Using PAP" on page 368
Refer to "Configuring the
Local Device to
Authenticate the Peer
Using CHAP" on page 368
Refer to "Configuring the
Local Device to Be
Authenticated by the Peer
Using PAP" on page 369
Refer to "Configuring the
Local Device to Be
Authenticated by the Peer
Using CHAP" on page 369
Refer to "Configuring PPP
Negotiation" on page 370
Refer to "Configuring PPP
Link Quality Control" on
page 373
Refer to "Enabling the PPP
Accounting Statistics
Function" on page 373
Configuring PPP 367
Remarks
-
-
Optional
By default, PPP is used.
Optional
10 seconds by default
Optional
PPP authentication is
disabled by default
Optional
PPP authentication is
disabled by default
Optional
Optional
Optional