Configuring Ce1/Pri Interface (In Pri Mode) - 3Com MSR 50 Series Configuration Manual

108 C 4: WAN I
HAPTER NTERFACE
n
Configuring CE1/PRI
Interface (in PRI Mode)
C
ONFIGURATION
To do...
Set the interface to operate in
CE1/PRI mode
Bundle timeslots on the
interface into channel sets
Set other interface parameters See
A CE1/PRI interface in CE1/PRI mode can be used as a CE1 interface where a serial
interface is created upon creation of a channel set. You may bundle timeslots on a
CE1/PRI interface into up to 31 channel sets.
For each channel set, the system automatically creates a serial interface numbered
serial interface-number:set-number. This interface is logically equivalent to a
synchronous serial interface where you can make other configurations about:
Data link protocol such as
■
Configuration" on page
"IP Addressing Configuration" on page 623
■
"Backup Center Configuration" on page 1961
■
primary or secondary interface for backup
"NAT-PT Configuration" on page 679
■
on page 1794 if a firewall is to be set up
The timeslots on a CE1/PRI interface can be bundled into either channel sets or a
PRI set, but not the both, at a time.
Follow these steps to configure a CE1/PRI interface in PRI mode:
To do...
Enter system view
Enter CE1/PRI interface view
Set the interface to operate in
CE1/PRI mode
Bundle timeslots on the
interface into a PRI set
Set other interface parameters See
A CE1/PRI interface in CE1/PRI mode can be used as a PRI interface where only one
PRI set can be created.
For the PRI set, the system automatically creates a serial interface numbered serial
interface-numbe:15. This interface is logically equivalent to an ISDN PRI interface
where you can make other configurations about:
Use the command...
using ce1
channel-set set-number
timeslot-list list
"WAN Interface
Configuration" on page 99.
"PPP and MP Configuration" on page
2385, "X.25 and LAPB Configuration" on page 283
if the interface is used as a
and "Configuring a Packet Filter Firewall"
Use the command...
system-view
controller e1 number
using ce1
pri-set [ timeslot-list list ]
"WAN Interface
Configuration" on page 99.
Remarks
Optional
The default operating mode is
CE1/PRI mode.
Required
Optional
363, "VoFR
Remarks
--
Required
Optional
The default operating mode is
CE1/PRI mode.
Required
If no timeslot range is
specified, all timeslots except
timeslot 0 form a 30B + D
ISDN PRI interface.
Optional