Configuring Is-Is Basic Functions; Configuration Prerequisites; Configuration Procedure - 3Com MSR 50 Series Configuration Manual

Configuring IS-IS Basic
Functions
Configuration
Prerequisites

Configuration Procedure

Configuration Task
"Tuning and Optimizing
IS-IS Network" on page 898
"Configuring IS-IS GR" on page 904
Before the configuration, accomplish the following tasks first:
Configure the link layer protocol.
■
Configure an IP address for each interface, and make sure all nodes are
■
reachable.
Follow these steps to configure IS-IS basic functions:
To do...
Enter system view
Enable IS-IS routing process
and enter its view
Assign a network entity title
(NET)
Specify a router type
Return to system view
Enter interface view

Configuring IS-IS Basic Functions

"Configuring a DIS Priority for
an Interface" on page 898
"Configuring IS-IS Timers" on
page 899
"Disabling an Interface from
Sending/Receiving IS-IS Hello
Packets" on page 900
"Configuring LSP Parameters"
on page 900
"Configuring SPF Parameters"
on page 901
"Configuring Dynamic Host
Name Mapping" on page 902
"Configuring IS-IS
Authentication" on page 902
"Configuring LSDB Overload
Tag" on page 903
"Logging the Adjacency
Changes" on page 904
"Enabling an Interface to Send
Small Hello Packets" on page
904
"Enabling IS-IS Trap" on page
904
Use the command...
system-view
isis [ process-id ]
[ vpn-instance
vpn-instance-name ]
network-entity net
is-level { level-1 | level-1-2 |
level-2 }
quit
interface interface-type
interface-number
893
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
--
Required
Not enabled by default
Required
Not assigned by default
Optional
The default type is level-1-2.
--
--