Enabling Interface Policy Routing; Displaying And Maintaining Ip Unicast Policy Routing Configuration - 3Com MSR 50 Series Configuration Manual

642 C 42: IP U
HAPTER NICAST
Enabling Interface Policy
Routing
Displaying and
Maintaining IP Unicast
Policy Routing
Configuration
P R C
OLICY OUTING ONFIGURATION
The system policy routing is used to route packets generated by the local device.
You can enable the interface policy routing and the system policy routing
respectively. Only one policy can be referenced when system policy routing is
enabled.
Follow these steps to enable the system policy routing:
To do...
Enter system view
Enable system policy routing
and reference a policy
Interface policy routing is applied to packets arriving on an interface. Only one
policy can be referenced when the policy routing is enabled on an interface.
Follow these steps to enable interface policy routing:
To do...
Enter system view
Enter interface view
Enable interface policy routing and
reference a policy
To do...
Display information about
system and interface policy
routing
Display the setting
information of policy routing
Display policy routing
statistics
Display the information of
policy routing based on a
specified policy
Clear the statistics of policy
routing based on a specified
policy
Use the command...
system-view
ip local policy-based-route
policy-name
Use the command...
system-view
interface interface-type
interface-number
ip policy-based-route
policy-name
Use the command...
display ip policy-based-route
display ip policy-based-route setup
{ interface interface-type interface-number
| local | policy-name }
display ip policy-based-route statistics
{ interface interface-type interface-number
| local }
display policy-based-route
[ policy-name ]
reset policy-based-route statistics
[ policy-name ]
Remarks
-
Required.
Disabled by default.
Remarks
-
-
Required
Disabled by default.
Remarks
Available in any
view
Available in user
view