Checking Existence Of Pvcs When Determining The Protocol State Of An Atm P2P Sub-Interface; Configuring Pvc Parameters - 3Com MSR 50 Series Configuration Manual

Checking Existence of
PVCs When Determining
the Protocol State of an
ATM P2P Sub-interface
Configuring PVC
Configuring PVC
parameters
To do...
Set the MTU for the ATM
sub-interface
c
CAUTION:
When creating an ATM sub-interface, the two keywords p2mp and p2p are
■
available. The format of the command is interface atm
interface-number.subnumber [ p2mp | p2p ].
When entering the view of an existing ATM sub-interface, the two keywords
■
are not available. The format of the command becomes interface atm
interface-number.subnumber.
Follow these steps to check existence of PVCs when determining the protocol
state of an ATM P2P sub-interface:
To do...
Enter system view
Create an ATM sub-interface
and enter its view
Check existence of PVCs
when determining the
protocol state of the ATM P2P
sub-interface
Follow these steps to configure a PVC:
To do...
Enter system view
Enter ATM interface view or
ATM sub-interface view
Create a PVC, and enter PVC
view
Set the AAL5 encapsulation
protocol type for specified PVC
Use the command...
mtu mtu-number
Use the command...
system-view
interface atm
interface-number.subnumb
er p2p
atm-link check
Use the command...
system-view
interface atm
{ interface-number |
interface-number.subnu
mber }
pvc { pvc-name [ vpi/vci ]
| vpi/vci }
encapsulation
aal5-encap
Configuring PVC
Remarks
Optional
1500 bytes by default
Remarks
-
Required
By default, the sub-interface is
configured as
point-to-multipoint (p2mp).
Required
By default, the protocol state of
the ATM P2P sub-interface is
consistent with the state of the
physical interface.
Remarks
-
-
Required
By default, no PVC is created.
Optional
By default, aal5snap
encapsulation is adopted.
131